"Walter Maxwell" wrote in message
...
On Fri, 20 Aug 2004 14:48:41 -0500, "Crazy George"

wrote:

What we encountered were dynamic range problems. The instrument operates
as
HP says, but if a strong enough interfering signal appears at an input,
it
overloads the first(usually) active device, causing various unwanted
products to appear in band, and sometimes desensitizing the channel.
Urban
problem with many other radio services nearby, and it doesn't help to be
under the landing path of USAF aircraft with their jammers still active
either.
Hi George,

I understand the situation you encountered, but as I understand the 'other
John's' situation, he was sufficiently far from strong RF fields such that
there
would be no problem with dynamic range. My interest is what the meters
showed on
his 8405 that would be recognized as negative resistance.

Walt, W2DU


Hi, Walt -

I'm sorry to say that I did not keep the data. Shame on me. But I will keep
the data the next time it comes up (if it does) and I will post it here. As
I said, I have not had negative resistance show up while using the dual
directional coupler, only when using the power splitter and pads. Different
math relations were used to calculate the results from the two techniques,
so it might very well be that it will never show up again.

Our country property where the measurements were made is about 10 miles east
of Sulphur Springs, Texas, and about 80 or so miles from Dallas. There are
two radio stations there, one on 1230 kHz (1 kW) and one on 95.9 MHz (6 kW).
The nearest microwave tower is about 5 miles west of me and I don't think
I'm in the path. There are no hams closer than 8 miles to me.

The more I think about this, the more convinced I become that I flubbed the
readings or the calculations. I am learning that you cannot treat 2 meter
and 70 cm signals casually. For example, when placing a short on the load
port of the coupler for calibration purposes, I can see the phase changing
after the connector has made contact but is still being screwed down.

Thanks for your comments.

John