LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6   Report Post  
Old September 11th 03, 04:21 PM
Richard Harrison
 
Posts: n/a
Default

Mark Keith wrote:
"As far as noise, if the dipole and loop are both horizontal, there
should be little if any difference in noise received, unless the pattern
of the particular antenna favors the noise source."

I wrote that the loop was small at lower frequenciues such as those used
with power mains and BC band transmitters. This can be equalized by an
r-f choke across the receiver input to short out the low-frequency
interference. A folded dipole or loop antenna doesn`t need a choke.
Their configurations provide a short at low frequencies.

I noticed the hum pickup of car radios using untuned r-f anmplifiers
back in the 1940`s. They had no low-frequency, low-impedance path for
noise intercepted by the conventional whip antenna. Radios with a
conventional antenna coil had bo antenna hum problem.

Best regards, Richard Harrison, KB5WZI

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Distance to Link Coupling in a Loop Antenna Al Antenna 6 October 28th 03 12:02 AM
SWL tuning an MFJ loop? Hatfield Antenna 3 July 25th 03 11:44 PM
Snap-on choke hurts shielded loop Loopfan Antenna 3 July 14th 03 08:30 PM
Feedpoint impedence / wire diameter Tom Bruhns Antenna 0 July 10th 03 08:23 PM


All times are GMT +1. The time now is 01:52 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017