Home |
Search |
Today's Posts |
#13
![]() |
|||
|
|||
![]()
I am not satisfied that the original poster has not made a "mistaken
subjective observation" Don't think we have heard from him on this aspect. -- Caveat Lector "Roy Lewallen" wrote in message ... bob wrote: Expressed another way, is a non-resonant antenna sometimes better for reception than a resonant antenna? There are several possible causes here. Probably, on the design frequency, its antenna is probably matched to 50 ohms , for good transmission. A matched antenna does not necessarily give the best S/N for reception, and usually a mismatch does. Its hard to calculate. Although this can be true at VHF/UHF, where the receiver noise dominates, it's not true at HF, where the observation was made. At HF, external noise dominates, so the quality of impedance match makes no difference in S/N ratio. One filing mentions the possible change in pattern, and therefore a possible change in S/N. . . . I'm certain that's the explanation (assuming it's not a mistaken subjective observation) -- the noise is coming pedominantly from one direction, and by tuning the antenna a pattern null was created in that direction. Signals from other directions are then stronger than the reduced noise. I've often directed my 40 meter 4 square array toward the southwest to put a null toward the U.S. Midwest and Gulf Coast, where a lot of thunderstorms occur in the summertime. VKs jump out of the noise when I do that. Rotatable loop receiving antennas are often used in the same way, to null out noise coming from one direction. Roy Lewallen, W7EL |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Identify beam | Antenna | |||
Vee Beam info needed | Antenna | |||
Mosley CL-33 WARC beam assembly instructions? | Equipment | |||
Mosley CL-33 WARC beam assembly instructions? | Equipment | |||
FS: TA-33 Beam and CDE rotator | Swap |