I read in sci.electronics.design that Tom Ring
wrote (in ) about '1/4 vs
1/2 wavelength antenna', on Fri, 4 Mar 2005:
John Woodgate wrote:

I read in sci.electronics.design that Tom Ring
wrote (in ) about '1/4 vs
1/2 wavelength antenna', on Thu, 3 Mar 2005:


He forgot to mention that for that output impedance to be relevant, you
need superconducting wire to the speakers as well as superconducting
voice coils.


See the last sentence, about the effect of an **8 ohm** source impedance
on damping.

Oh, and going from 8 ohms output impedance to 10e-7 (unless I
miscounted) would take the damping factor from 1 to 8e7, which is a bit
more than 2. Ignoring the speaker wires of course.

Also ignoring the ***voice-coil resistance***. If that is included, as
it must be for a correct analysis, you get 2.

F Langford-Smith 'invented' the concept of damping factor, and around
1949 accepted the point made by James Moir that, by not properly taking
into account the effect of the voice-coil resistance, it was a seriously
misleading concept. Yes, 60 years later, people are still being misled.
--
Regards, John Woodgate, OOO - Own Opinions Only.
The good news is that nothing is compulsory.
The bad news is that everything is prohibited.
http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk

John Woodgate wrote:

I read in sci.electronics.design that Tom Ring
wrote (in ) about '1/4 vs
1/2 wavelength antenna', on Fri, 4 Mar 2005:

Also ignoring the ***voice-coil resistance***. If that is included, as
it must be for a correct analysis, you get 2.

F Langford-Smith 'invented' the concept of damping factor, and around
1949 accepted the point made by James Moir that, by not properly taking
into account the effect of the voice-coil resistance, it was a seriously
misleading concept. Yes, 60 years later, people are still being misled.

Good point. I stand corrected.

The only nit I would pick would be that impedance be used, since you
need to measure it at the frequency(ies) in question, not DC. And then
there is that pesky crossover in most systems. Personally I like biamping.

tom
K0TAR

I read in sci.electronics.design that Tom Ring
wrote (in ) about '1/4 vs
1/2 wavelength antenna', on Sat, 5 Mar 2005:
Personally I like
biamping.

So do I.
--
Regards, John Woodgate, OOO - Own Opinions Only.
The good news is that nothing is compulsory.
The bad news is that everything is prohibited.
http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk