Home |
Search |
Today's Posts |
#11
![]() |
|||
|
|||
![]()
I read in sci.electronics.design that Tom Ring
wrote (in ) about '1/4 vs 1/2 wavelength antenna', on Fri, 4 Mar 2005: John Woodgate wrote: I read in sci.electronics.design that Tom Ring wrote (in ) about '1/4 vs 1/2 wavelength antenna', on Thu, 3 Mar 2005: He forgot to mention that for that output impedance to be relevant, you need superconducting wire to the speakers as well as superconducting voice coils. See the last sentence, about the effect of an **8 ohm** source impedance on damping. Oh, and going from 8 ohms output impedance to 10e-7 (unless I miscounted) would take the damping factor from 1 to 8e7, which is a bit more than 2. Ignoring the speaker wires of course. Also ignoring the ***voice-coil resistance***. If that is included, as it must be for a correct analysis, you get 2. F Langford-Smith 'invented' the concept of damping factor, and around 1949 accepted the point made by James Moir that, by not properly taking into account the effect of the voice-coil resistance, it was a seriously misleading concept. Yes, 60 years later, people are still being misled. -- Regards, John Woodgate, OOO - Own Opinions Only. The good news is that nothing is compulsory. The bad news is that everything is prohibited. http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Discone antenna plans | Antenna | |||
The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Antenna | |||
Poor quality low + High TV channels? How much dB in Preamp? | Shortwave | |||
X-terminator antenna | CB | |||
Outdoor Antenna and lack of intermod | Scanner |