"Hal Rosser" wrote in message
. ..


The type of lamp cord common in South Africa (don't know about other
countries): Two conductors of 0.75mm^2 cross sectional area insulated
with
about 1mm of white pvc and a spacing of around 2.5mm has an impedance of
aproximately 60 Ohms. Close enough to 50 to use for quick&dirty dipoles
without balun or tuner. Though have no idea of the velocity factor and
don't
really need to bother as I just pull apart the cord until I have what
looks
like enough to get a good swr. Then fine tune by pulling more or
cutting.
A
swr of about 1.3 is achievable.

73
Roger ZR3RC

I've heard that lamp cord was low-impedence but had forgotten what the
impedence was.
Do you just use some tape once you unzip the length you need - to keep it
from self-zipping from the tension?
I also heard it had a pretty high loss - But like you say - for a
quick-and
dirty antenna and feedline, its a good trick for a ham's bag.
Thanks for the info.


Duct tape, insulation tape, etc. or my personal favourite - a cable tie.

Confuscious Say: Ham who leaves home without screwdriver, duct tape and
cable tie, is same as doctor without stethoscope and syringe.

73 Roger ZR3RC