About Us

May 26th 05, 10:59 PM

On 26 May 2005 07:09:12 -0700, wrote:

Vince wrote:
What danger, if any, is there when resonant 40m, 30m, and 20m dipole
elements in parallel with RG58 coaxial cable feed and the radio's
internal ATU are used on the 17m, 15m, 12m, and 10m bands?

The ATU permits loading of the non-resonant bands to full RF output,
but I have had a blown capacitor that is used within the LowPassFilter
for the 40m channel and another capacitor blown within the 12m/10m
channel.

73, de ~ Vince ~

Hi Vince, do you know if the caps in the filters blew while the ATU
was in the process of "tuning"? Or did they blow during normal
operation after the ATU had already "tuned"? The filters should see
their designed for impedance after the ATU successfully "tunes" to your
antenna system impedance. The filters will see all sorts of impedances
during the tunning process, and this time the caps in the filters will
be under the most stress. Another could be a connection problem in
your antenna system causing the impedance the ATU sees to change
intermittently.
My xcvr instruction book says use the lowest possible rf output power
setting when using the internal automatic antenna tuner.
Gary N4AST

Hi Gary:

I normally leave the ATU in my FT1kD enabled at all times.
In both instances, the ATU had finished tuning for the aerial wires.
Operation on the 40m band actually does not require the ATU to be
enabled, since the VSWR is very good across the lower 100 kHz of the
band.

All caps within the LPF band/channel were replaced at the same time; I
do not know which cap blew out or was the cause of no RF output at the
time on that band. The last time that this happened, (12m/10m LPF) I
did notice that a capacitor closest to the PA finals showed indication
of swetting.

73, de ~ Vince ~
WA2RSX
Stuck on IOTA NA-026

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Experience with Resonant Feedline Dipoles requested	Terra Dactyl	Antenna	1	January 21st 05 08:12 PM
Resonant and Non-resonant Radials	Reg Edwards	Antenna	1	January 8th 05 11:27 PM
GRAYLAND 2004 FALL DXPEDITION: Compiled Logs for Oct 15-17 (Part 1)	4nradio	Shortwave	4	November 1st 04 11:44 PM
Two dipoles on one feed line?	KAZeringue	Antenna	0	August 5th 04 05:04 PM
Dipoles & Tuned Circuits	Reg Edwards	Antenna	0	October 17th 03 12:54 AM

Menu

About Us