LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #4   Report Post  
Old September 8th 05, 04:02 AM
 
Posts: n/a
Default

Mike:

One thing that no one will tell you is why manufacturers use plated hardware
which rusts instead of stainless. Cost? No. Stainless will not stay tight,
while plated hardware will rust up and then never loosen. So, if you use
stainless, it is highly desirable to use Nylon insert locknuts or else
carefully double nut everything, and add Loctite before assembly. It is no
fun finding another piece of the antenna at the bottom of the tower every
day after the wind blows a while.

--
Crazy George


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Questions -?- Considering a 'small' Shortwave Listener's (SWLs) Antenna RHF Shortwave 1 January 24th 05 09:37 PM
Ideas for a homemade mobile antenna. Chris CB 152 June 24th 04 02:13 AM
Help -- Need Installation Advice for Vertical Antenna Rob Antenna 5 May 4th 04 07:18 AM
Short STACKED Vertical {Tri-Band} BroomStick Antenna [Was: Wire ant question] RHF Shortwave 0 February 23rd 04 12:59 PM
Poor quality low + High TV channels? How much dB in Preamp? lbbs Shortwave 16 December 13th 03 03:01 PM


All times are GMT +1. The time now is 01:18 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017