Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
MFJ-269 Antenna/SWR/RF Analyzer
On Fri, 04 Nov 2005 19:43:07 GMT, John Ferrell
wrote: I am considering ordering the MFJ-269 HF/VHF/UHF Antenna/SWR/RF Analyzer. It sounds like a Swiss Army knife device and I should be able to send a lot of old equipment to Ebay. Does anyone have any comments to make on it? Good or bad? I have read the review in May 2005 QST and the manual available at their website. John Ferrell, W8CCW My main complaint is if you punch buttons in the wrong sequence to activate its 440 mhz capability, you can blow a diode, or so I've read in the eHam reports. I haven't done it yet, but the it apparently can happen. The capabilities on 440 mhz are quite limited, compared to other frequencies, so you may want to consider the 259, unless you need to measure swr on 440. bob k5qwg |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Spectrum Analyzer vs. Field Strength Analyzer | Homebrew | |||
practrical spectrum analyzer | Policy |