ORIGINAL MESSAGE:

On Sat, 31 Dec 2005 12:14:38 -0500, Amos Keag
wrote:

1) Make sure you have a good connection from equipment cases to AC Power
main ground/earth. I use a 1/2 inch copper pipe on the table where my
station is mounted. Each piece of equipment on the table, transceivers,
amplifiers, power supplies, computer, are individually bonded to this
copper pipe. This 1/2 inch copper pipe is then connected to earth ground
by a #6 AWG wire run directly to the electrical service panel where it
is connected to the earth connection.


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Why?

73, Bill W6WRT