About Us

Richard Knoppow · March 20th 08, 12:42 PM posted to rec.radio.amateur.boatanchors

"K3HVG" wrote in message
. ..
wrote:
hi guys,
i'm in the process of restoring a 180a. tubes are
good, i
changed the electrolytics. rcvr does need a bit of hf
alignment but
works well now except for the last problem. so here it
is...all
functions work well on the lower bands. when the 2
highest bands are
selected, triple conv. kicks in, am reception works well,
but ssb & cw
does not. the ssb audio & the cw notes have a raspy or
burbelly(for
want of a better word) sound. i can't understand why,
because ssb &
cw work fine on lower bands. i have the bama prints, &
poked around
checking resistance & voltages. can't find any far off.
any help
would be greatly appreciated. it's a nice vy clean rig
with clock &
noise blanker, i have matching spkr also. i want to set
up an swl pos.
tnx pete k2iqk

I think you'll find that the conversion oscillator for the
upper bands is the problem. I had to work mine over
(read: component re-build), to include replacing the
"good" tube and cleaning the socket. It was a shotgun
re-build but it did cure the problem(s) in the end. The
instability I had was genuinely a pain-in-the-%$#!

This is a crystal controlled oscillator operating at
around 2580Khz, you should be able to pick it up with
another receiver to see if its unstable. Keep in mind that
the crystal itself can go bad.

--
---
Richard Knoppow
Los Angeles, CA, USA

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HQ180A questions	[email protected]	Boatanchors	0	February 13th 08 03:54 AM
HQ180A restore	[email protected]	Boatanchors	23	February 6th 08 05:58 PM
HQ180A Record Price?	Dan Robinson	Shortwave	6	February 20th 04 11:25 PM

Menu

About Us