Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]() "Paul P" REMOVE paul @ REMOVE ppinyot . REMOVEcom wrote in message ... I would need a picture and have a go at it in the Garage. The garage is my junk box, especially according to my wife :~) I have old chassis laying around to scrounge from and boxes of unsorted assorted parts. It is summer and I could use some time going over some stuff with the garage doors open. Paul P. Send a pix here also- I have a good stock of piston caps- if that is what you mean by tubular. Dale W4OP |
#2
![]() |
|||
|
|||
![]() "Dale Parfitt" wrote in message ... "Paul P" REMOVE paul @ REMOVE ppinyot . REMOVEcom wrote in message ... I would need a picture and have a go at it in the Garage. The garage is my junk box, especially according to my wife :~) I have old chassis laying around to scrounge from and boxes of unsorted assorted parts. It is summer and I could use some time going over some stuff with the garage doors open. Paul P. Send a pix here also- I have a good stock of piston caps- if that is what you mean by tubular. Dale W4OP Yes, that's what I mean! But I can't post pictures to a newsgroup can I? Its definitely C22 2-12 pf that I need, although range 3 is actually working! I have a new problem and can't understnd the reason for it. The tested voltage between grids of V1, 2 and others to the slider of the RF gain control is meant to be - 1.2v. It was OK. Since I've re-capped and changed a few resistors, it is +.5. Any ideas? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
XM radio woes.... | Shortwave | |||
RFI woes | Shortwave | |||
24 GHz woes? | Policy | |||
Cell phone woes | Policy | |||
Magloop woes | Antenna |