highlandham wrote in news:lt5mcm$7ud$1@dont-
email.me:

Somewhere on the Net is a poster of silly screws to handle such problems.
along the lines of a screw with a bit shifted sideways!

Anyone got the URL?


========================
These screw type punchers were/are available from Radio Spares (RS).
I have a few sizes up to 30 mm diameter.


I think he had something far sillier in mind. Pythonesque, even. But I
know the puches you mean, I have a couple for 20mm and 16mm, I considered one
for 25 pin D-sub but in the end I never wanted to repeat enough to justify
anything other than finely dotted drill-lines followed by knocking out the
middle bit and light filing to clean up. Those hole puches don't always work
well, especially on thicker panels, or panels that already have a tough
enamel type coating. They're also not cheap, I just kept some for hole sizes
I did need to use a lot.