Does anyone know where I might find a replacement element for an
Electro-Voice 664 microphone? It's a vintage mike.

Great mike for tube ham rigs as well as for general P.A. use. The element I
have - the coil connections have corroded away. :-(

Great sounding mike - then went dead as described.

Have tried electrovoice.com, no luck. Many vintage mike websites, but no
one selling elements.

Thanks,

Mike
KB8RJO

Mike Mayer wrote:
Does anyone know where I might find a replacement element for an
Electro-Voice 664 microphone? It's a vintage mike.

Nope. EV no longer has elements. The coils on these get bent and then
go open. As far as I know, nobody can rebuild dynamic mike coils.

Have tried electrovoice.com, no luck. Many vintage mike websites, but no
one selling elements.

They don't exist. Spend $50 and get a new one at a hamfest.
-scott


--
"C'est un Nagra. C'est suisse, et tres, tres precis."

Scott Dorsey wrote:

Mike Mayer wrote:


Does anyone know where I might find a replacement element for an
Electro-Voice 664 microphone? It's a vintage mike.



Nope. EV no longer has elements. The coils on these get bent and then
go open. As far as I know, nobody can rebuild dynamic mike coils.



Have tried electrovoice.com, no luck. Many vintage mike websites, but no
one selling elements.



They don't exist. Spend $50 and get a new one at a hamfest.
-scott




It probably won't fit and it is not "original" but I have used the
receiver element from those old
black "500 type" telephones. The receiver makes a good dynamic
microphone with an
impedance of ( I think) about 500 Ohms.

Bill K7NOM