Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
FWIW, I have never seen anything damaged that was wrapped in at least 4
layers of LARGE type bubble wrap. No need to double box if you use that stuff usually. For ultimate control panel protection, go to a fabric or upholstery shop and get some high density foam in 4" or 5" thickness and place it over the control panel. THEN wrap with large bubble wrap. The HD foam is NOT cheap, however, I paid $12 for a 24" x 24" pc last time I think. But sometimes you can get smaller scraps for less. The upholstery shops are usually better about selling stuff under 18" cheap because they cant use it in a regular chair or couch cushion. Mark Oppat "Bill Powell" wrote in message ... To-date, I have found VERY FEW (eBay) people who have the FOGGIEST idea of how to properly pack a boatanchor. Especially the "trust me - I'm an eBay professional" types. So... I've been insisting on (and paying for) double boxing and heavy cardboard boxes. However. . . The "Joe Average" average double-box job can (usually) lead to a crunched front panel - or worse. A Knight transmitter I recently received was double-boxed with the inner cushioned from the outer with a 1.5" layer of peanuts. However, the front-panel of the transmitter had been stood off the side of the inner box with a thick sheet of solid, hard styrofoam. Right now I'm assuming that the "locked" shafts are simply due to the knobs being scrunched just a little bit tighter against the front panel than they should be. I hope. OTOH, a Johnson Viking Valiant (just add chain - no concrete required) I received was so well packed that despite being dropped, the only things amiss were a "floating" audio interstage under the chassis and severely bent mountings on the mod transformer: absolutely NO front panel damage or tube breakage! My quest for knowledge: Has anyone here tried DIY foam-in-place? I'm talking about embalming the hunk-o-iron in double heavy duty trashbags, shooting "some" (think of a kid with a can of whipped cream) of the DIY spray-in foam insulation into the 4 corners of the inner box and then setting the bagged anchor into the mess till it sets. A follow-up would (hopefully) lock the bagged goodie more-or-less into the middle of the box. Or am I just gonna make a nasty mess? TIA, Bill - WB1GOT Oh - getting the thing back out is someone elses problem. :-) |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Does it matter about packing? | Boatanchors |