"Bob Spooner" wrote in message
...
I have a TS-700SP with no manual. Can anyone tell me the model of the
Kenwood that came with it?


You need a 500ohm dynamic mic, assuming the set hasn't been modified.

Original was a 4 pin plug/socket.

--
73
Brian, G8OSN
www.g8osn.org.uk

Thanks. I've been using a Drake desk mike, and have had to turn the gain all
the way up but my FM deviation still sounds low, so I'm hoping to find the
original Kenwood mike model to look for. But with the impedance information
from you I may be able to find a substitute.

73,
Bob AD3K

"Brian Reay" wrote in message
...
"Bob Spooner" wrote in message
...
I have a TS-700SP with no manual. Can anyone tell me the model of the
Kenwood that came with it?


You need a 500ohm dynamic mic, assuming the set hasn't been modified.

Original was a 4 pin plug/socket.

--
73
Brian, G8OSN
www.g8osn.org.uk

I have a pl board that will work in that radio. If I remember right, that
was the all mode from Kenwood? I am a blind person, and i would count the
turns on the knob to tell what frequency I was on.

"Dana" wrote in message
.com...
I have a pl board that will work in that radio. If I remember right, that
was the all mode from Kenwood? I am a blind person, and i would count the
turns on the knob to tell what frequency I was on.


Dana,

I would be interested in knowing what pl board you use and how yours is
attached. Thanks.

73,
Bob AD3K