Home |
Search |
Today's Posts |
#18
![]() |
|||
|
|||
![]()
YOU GUESS ARE SO SMART, WHAT THE **** YOU DOING ON CB ?
"Frank Gilliland" wrote in message ... On Wed, 06 Oct 2004 07:19:53 -0400, Dave Hall wrote in : snip Geeze! Why don't you tell him what you REALLY think. ;-) Actually the term "compression" refers to the condition where a normally linear device, starts to lose that linearity. If the gain of your amp is 10 db, then 5 watts in should give 50 watts out. 10 watts in should give 100 watts out. If 15 watts in only results in 120 watts out, you are now "in compression". You call that clipping, but compression is also a valid term for this condition. We use this term all the time where I work. Granted the amps I work with are not as powerful, they are still governed by the same characteristics. Usually once "compression" is reached the incidents of second order harmonic generation increases disproportionately with the output, usually at a 2:1 ratio. Let's try and clarify a few terms here..... Clipping -- distortion that occurs on the top of a waveform due to the signal exceeding the limitations of the circuit. Limiting -- the result of intentionally preventing a signal from exceeding a given level. This can be done by clipping, automatic gain control, or both. Compression -- a term usually applied to audio conditioning where the amplification of a signal is varied inversely to it's input level. One of the most common types of audio compressor is called "constant volume amplifier". But the problem here is that the term 'compression' has beed adopted by voodoo techs as a euphamism for 'clipping', making it sound as if the distortion-causing effect is not only benign, but sometimes preferred. It is neither. But you are right about one thing. a -33dbc harmonic rating from a single carrier signal is pretty poor. Perhaps a chebychev lowpass filter on the output will fix it up..... That would be nothing more than a kludge. The fault is in the design. The response isn't even close to linear. That may be due to the bias class, the bias regulator, the choice of active device, or just crappy engineering overall. I suspect it's a little of everything. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Some questions form a RDS's newbie | Broadcasting | |||
Yaesu FT-790R user manual? | Equipment | |||
Newbie | Homebrew | |||
Newbie | Homebrew | |||
User manual needed for Standard GX 1510 | Equipment |