Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
Den 02.11.2009 18:20, skrev John W:
Hi Torbjørn I don't know much about SeaTTY but most other FAX software states that you must tune 1.9kHz below the frequency of the station and use USB. LSB usage is rare. HF fax is usually 120, 90 or 60 LPM (lines per minute) with 576 or 288 IOC (index of correlation). So make sure everything is set up properly. If there is an APT setting then that will probably be referring to 137MHz satellite transmissions. Some software uses the start tone of the FAX transmission to determine the IOC value. Hope this Helps. 73 JOHN M5AML Many thanks for the info there. I did manage to find a solution, it turned out that my soundcard needed a calibration. Obvious no problems with normal audio/movies but with SeaTTY it was quite needed. 73 Torbjorn, LA6WLA |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Seatty 1.70 is published | Digital | |||
DxSoft "TrueTTY" Or "SeaTTY" Opinions On ? | Shortwave | |||
SeaTTY 1.23 is published (RTTY/NAVTEX/HF-FAX decoder) | Digital | |||
SeaTTY 1.23 is published (RTTY/NAVTEX/HF-FAX decoder) | Digital |