Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old June 27th 05, 08:20 PM
Charlie
 
Posts: n/a
Default

Thanks for your tips Rob...

--

Charlie
Ham Radio - AD5TH
www.ad5th.com
Deep South 2 Meter SSB Net
www.deepsouthnet.net





"Rob" wrote in message
.. .
Charlie,

It's very obvious a lot of hard work went into that project, this makes it
even harder to face criticism, but don't lose sight of the fact that it's
constructive (even though it's deteriorating rapidly.) There really are
numerous problems with your installation, and some will inevitably lead to
catastrophic failure and potential loss of life.

Be careful around that thing until you can fix it up. In the least,
install dedicated anchor points set in a sizeable concrete base, shorten
your top mast and get a thrust bearing up there. Put at least 1/3 of your
rotatable mast below the bearing.

This is by no means a complete list, but I think the majority of readers
will agree it's a good place to start.

Rob




Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Tower Resonance Breaker? KA9S-3_Jeff Antenna 4 March 12th 05 10:39 PM
Single ground Bill Ogden Antenna 26 November 25th 04 03:47 AM
Is lighting nuts? CIL Antenna 29 October 23rd 04 11:38 PM
PRESS RELEASE: HCDX Online Log 1.0 released Risto Kotalampi Shortwave 0 January 12th 04 08:04 AM
FS: U.S. Tower TX489 MDPL 89' Telescopic tower Rich W6VX Equipment 0 August 28th 03 02:46 AM


All times are GMT +1. The time now is 11:44 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017