LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #4   Report Post  
Old October 1st 03, 01:57 AM
Jerry
 
Posts: n/a
Default


"Daniel C. Mckenzie" wrote in message
...
Looking for opinions on the performance of these mobile antennas.
I'm planning on going mobile, looking at the FT-100 or IC-706, but
I'd like to go with something designed as a well organized system. So
I could go with the FT-100 / ATAS 120, or the IC-706 / AH-4, or
maybe either one with one of the various screwdrivers. I've heard that
the screwdrivers perform much better than either ATAS or AH-4.
What's your experience? Do the matched systems really work well?
Do you think a screwdriver with external controller or even manual
tuning would be much better? How about guying? I see that most
screwdriver antennas require guying but not the Yaesu or Icom.
Are there any web sites I can go to with real measured data, not
just anecdotal stories?

Thanks for your time!

Dan, W9FCC



The screwdriver would get the nod in just about every case--particularly at
40 Meters and below. While I can't
point you in a particular direction on the spur of the moment, It is a known
fact that there is really no such thing as a "tuner". No matter what device
you use to "fool" the rig into thinking there is a resonant antenna out
there, there *really* is no substitute for a a resonant antenna. A properly
set up screwdriver will stomp on
a tuner or an ATAS and the ATAS would be simply because you are scrunching
the antenna down into a much smaller package. For the best results,
nothing beats
a BIG, UGLY antenna for HF--again where it concerns the lower bands. Of
course, I am sort of partial being that I make Screwdrivers (Carolina
Cyclone), but *I* would choose the SD and 706 combo. I also supply a
little tuning module with each antenna that allows you to
easily move your antenna coil into the right position. The
rig emits a tone and a 10-15 watt carrier. You then operate the screwdriver
motor up/down as needed to position your antenna correctly while observing
the SWR
on the 706's display. It is simple, quick, and beats the cost of those
auto-positioners all to pieces ($200 vs. about $15 for the module.)

Whatever antenna you choose, most people will agree that, while other
antennas can be quite satisfactory, no other antenna beats the SD or a large
center-loaded antenna. If you are satisfied with so-so performance, then
even hamsticks *work* (after a fashion). Me, I HATE a
puny HF mobile signal.


73

Jerry
K4KWH

www.qsl.net/k4kwh




 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
screwdriver for RV Jeremy Salch Antenna 21 March 19th 04 06:15 PM
Question on HS Screwdriver land installation Paul Braun Antenna 2 November 13th 03 08:06 PM
Opinions on Yaesu "ATAS" Mobile Antenna? (from experienced users, please) Carl R. Stevenson Antenna 1 October 16th 03 03:10 AM
DK3 screwdriver antenna and artificial ground Pierre Antenna 5 October 14th 03 04:05 PM
ATAS 120 Rich Antenna 3 July 18th 03 08:46 AM


All times are GMT +1. The time now is 01:12 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017