| Home |
| Search |
| Today's Posts |
|
#9
|
|||
|
|||
|
The 520 and 530 are about as close as an elephant and a donkey.... About the
only thing they have in common is tubes finals and the brand. -- Clif Holland KA5IPF www.avvid.com "Fred McKenzie" wrote in message ... In article om, "billcalley" wrote: 2. Find the single trimmer capacitor located near the 500Hz CW filter (the trimmer capacitor will be able to shift the 500Hz CW filter center frequency by some small amount). Bill- You may be able to accomplish your goal without a counter, but the trimmer you need to adjust is one of a group of three next to three crystals on the carrier unit. It is probably not on the filter board unless the two boards are combined in the TS-530. I don't know for sure if the TS-520 manual is applicable. Although it shows the crystals and trimmers in a photo and on the circuit diagram, I couldn't find a procedure for their adjustment. It would help if you could find a copy of the TS-530 service manual. Fred K4DII |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Question for Techs not upgrading to General question | Policy | |||
| A question on tube rigs in general, Kenwood in particular | Boatanchors | |||
| Question on RFI and tube vs newer rigs | Boatanchors | |||
| kenwood/yaseu rigs ++ | Equipment | |||
| kenwood/yaseu rigs ++ | Equipment | |||