About Us

October 15th 03, 04:57 PM

Gary P. Fiber wrote in message . ..
On 9 Oct 2003 23:32:41 -0700, (Michael Ko) wrote:

Michael,

I used to work at Icom,been away for over 2 years now. I have used the
CS-T2. BUT I am not aware of any CPU change that would leave out the
ANI mode. I do not remember any optional board requirements for the
ANI mode only the CS-T2 software was required to enable that mode.
It might be there was something more desired in the T2 so the factory
made such a change. Yes maybe another call to Icom for clarification
of the possible trouble would be in order.

In past years a cpu change happened on the 2SAT and 24AT for offset
tuning around serial 9500. The original offset tuning step was
limited to 25 khz steps and we complained so the factory changed to a
cpu that allowed tuning steps of 5 khz which was better for odd offset
repeaters and MARS operations.

Gary K8IZ
Washington State Resident
Registered Linux User # 312991

Update:
Called Icom again on 10/14. I told Icom support (different person)
that I have problem programming ANI mode into my Icom T2H. He
mentioned that T2H is an amateur radio, it should not have ANI mode.
But after checked on the manual, he agreed that it has ANI mode. And
again he walked me through the CST2 in the Common screen. I think we
all doing the correct setting "DTMF/ANI Mode" etc. He told me he will
check it up and call me back.

I will post the final result here for anyone who is interested in Icom
T2H ANI mode.

Michael KC8YJK

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mode for Best Throughput?	Andy Knitt	Digital	22	November 7th 03 01:31 AM
Mode for Best Throughput?	Andy Knitt	Digital	0	November 5th 03 02:56 AM
WTB Icom IC-245	NI4K	Boatanchors	0	October 29th 03 09:39 PM
"Remote Base" operation with Icom IC-2720H	Paul Ryan	Equipment	2	September 8th 03 09:49 PM
"Remote Base" operation with Icom IC-2720H	Paul Ryan	Equipment	0	September 8th 03 08:52 PM