IC-751 Scanning
 

I run an IC-751 with a Windom at 30'. The radio works fine after
replacing the old leaking caps. However, when trying to scan it will
not stop when the squelch opens. It just keeps scanning. Any
thoughts?

Thanks,
Doug/KB8M

IC-751 Scanning
 

On Wed, 23 May 2007, KB8M wrote:

I run an IC-751 with a Windom at 30'. The radio works fine after
replacing the old leaking caps. However, when trying to scan it will
not stop when the squelch opens. It just keeps scanning. Any
thoughts?

Thanks,
Doug/KB8M

Geez Doug I have had an old IC751 for years and did'nt even know it had
a memory scan on it so I took close look at mine and yep it shows a
scan button right above the MIKE gain control. It scans on the stuff
in the Memory chnls (1 thru 30) if I recall correctly. I thank you
for bringing that to my attention
Joe/KH6JF

IC-751 Scanning
 

The "frequency mode" scan functions under control of memory channels 1 & 2,
when both of these two memory channel frequencies are within the same
band ------ and the selected/activated vfo (VFO A OR VFO B) is also tuned to
this same band, repetitively scanning downward betweem the high frequency
amd the low frequency memory settings in memory channels 1 & 2..

My 751 continues to scan after the squelch is activated and stops when the
squelch is next closed.

Hope this may help.

Charles/W6JNF



"KB8M" wrote in message
oups.com...
I run an IC-751 with a Windom at 30'. The radio works fine after
replacing the old leaking caps. However, when trying to scan it will
not stop when the squelch opens. It just keeps scanning. Any
thoughts?

Thanks,
Doug/KB8M

IC-751 Scanning
 

I meant to comment on your replacement of "old leaking caps", but failed to
do so. I have not yet encountered any problem with the caps in my set.
Would you please provide a little info in this regard, such as how many and
what circuit boards were primarily involved. I don't have the internal
power supply installed and am using an external Kenwood PS-350.

Thanks in advance for any info re your cap replacement project.

Charles
W6JNF



"KB8M" wrote in message
oups.com...
I run an IC-751 with a Windom at 30'. The radio works fine after
replacing the old leaking caps. However, when trying to scan it will
not stop when the squelch opens. It just keeps scanning. Any
thoughts?

Thanks,
Doug/KB8M