Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old December 18th 03, 05:32 PM
Joshua G Senecal
 
Posts: n/a
Default Weller station gone bad--how to fix?

Hi all,

I have a Weller WTCPS soldering station with a 201U power supply and 201P
iron, using a 700 degree F tip. Last night I powered it up in preparation
for soldering some connectors, and a few minutes later I saw that the tip
and metal shaft of the iron were glowing red-hot.

Any ideas as to what is causing this, and will it be cheap to fix? Are
there any checks I can do to diagnose the problem? Or should I just dump
the thing and buy a new one? I bought the station over 11 years ago, in
practically new condition, at a yard sale for $5, so I got my money out
of it, but if a reliable fix is cheaper than purchasing a new soldering
setup I'd rather go that route.

Thanks!

-Josh, AE6IQ

--


Remove the reversed "nospam" in the address.

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Special event station F4ASK Dx 10 September 4th 04 12:16 AM
Special event station F4ASK Dx 0 September 3rd 04 04:55 PM
Amateur Radio Newsline™ Report 1400 ­ June 11, 2004 Radionews Dx 0 June 16th 04 08:34 PM
Amateur Radio Newsline™ Report 1400 ­ June 11, 2004 Radionews Dx 0 June 16th 04 08:34 PM
Weller station gone bad--how to fix? Joshua G Senecal Equipment 46 December 23rd 03 03:32 PM


All times are GMT +1. The time now is 05:25 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017