FT1000D extended TX
 

Hello,

I own a Yaesu FT1000D with firmware 6.00 and want to do the mod extended TX
but i do not succeed yet.
I followed the mod on mods.dk but no succes.
I saw the jumper 3 soldered already but do i've to remove the jumper ?
Is there another URL for info ?

Kind regards

--
Met vriendelijke groet,

Hans Pluijgers
HAMcall: PA3HGT

http://www.qsl.net/pa3hgt/

"PA3HGT" writes:

I saw the jumper 3 soldered already but do i've to remove the jumper ?

Yes. The solder ball is the jumper. Remove it. The tranciever still
lights the GEN light when out of it's programmed bands, but will transmit.
Be careful.

// marc

"PA3HGT" writes:

I saw the jumper 3 soldered already but do i've to remove the jumper ?

Yes. The solder ball is the jumper. Remove it. The tranciever still
lights the GEN light when out of it's programmed bands, but will transmit.
Be careful.

// marc

I wrote:

"PA3HGT" writes:

I saw the jumper 3 soldered already but do i've to remove the jumper ?

Yes. The solder ball is the jumper. Remove it. The tranciever still
lights the GEN light when out of it's programmed bands, but will transmit.
Be careful.

Or do I have it backwards and you need to add a solder ball? Damn, I
forget which way it was. In any case reverse it. If the pads are
connected remove the solder ball, if not connected then add one.

// marc

I wrote:

"PA3HGT" writes:

I saw the jumper 3 soldered already but do i've to remove the jumper ?

Yes. The solder ball is the jumper. Remove it. The tranciever still
lights the GEN light when out of it's programmed bands, but will transmit.
Be careful.

Or do I have it backwards and you need to add a solder ball? Damn, I
forget which way it was. In any case reverse it. If the pads are
connected remove the solder ball, if not connected then add one.

// marc

I removed the jumper and it's now fullrange TX.
In the schematic diagram is JP3 open ..... mistake of Yaesu ?
Thanks Marco for the info.



"PA3HGT" schreef in bericht
. nl...
Hello,

I own a Yaesu FT1000D with firmware 6.00 and want to do the mod extended
TX
but i do not succeed yet.
I followed the mod on mods.dk but no succes.
I saw the jumper 3 soldered already but do i've to remove the jumper ?
Is there another URL for info ?

Kind regards

--
Met vriendelijke groet,

Hans Pluijgers
HAMcall: PA3HGT

http://www.qsl.net/pa3hgt/

I removed the jumper and it's now fullrange TX.
In the schematic diagram is JP3 open ..... mistake of Yaesu ?
Thanks Marco for the info.



"PA3HGT" schreef in bericht
. nl...
Hello,

I own a Yaesu FT1000D with firmware 6.00 and want to do the mod extended
TX
but i do not succeed yet.
I followed the mod on mods.dk but no succes.
I saw the jumper 3 soldered already but do i've to remove the jumper ?
Is there another URL for info ?

Kind regards

--
Met vriendelijke groet,

Hans Pluijgers
HAMcall: PA3HGT

http://www.qsl.net/pa3hgt/