Home |
Search |
Today's Posts |
#4
![]() |
|||
|
|||
![]()
Steve,
Thanks for your comments. I suppose I haven't ruled out debris completely, but I cleaned it pretty well with IPA when I had it apart, then used canned air after reassembly. As you mentioned, I believe the problem is that adjacent turns of the spring are rubbing in certain positions, and possibly crossing, hence the "stick" problem. This is what I was trying to say when I mentioned the planar issue originally. It's hard to see, but it looks like there's a concentricity problem, too- before I attach the outer end of the spring the spiral looks fairly decent, but as soon as I move it into place and attach (solder) the outer tip, the turns are no longer evenly radiused from the center. Also, the travel is very smooth when the spring is removed, so again I believe this points to the spring as the culprit. Another thing I didn't mention before is that the meter requires greater current to cause FSD now than it did previously. And when I set the zero adjust it tends to under-report all readings, i.e., the line test gives a position of around 1/4 scale rather than 1/2 scale. Any advice? Thanks, Sam "Steve Nosko" wrote in message ... Been there, done that. Are you ABSOLUTELY sure there is no foreign matter in the movement somewhere. Frequently, some iron finings or whatever will get sucked into the magnets. The hint is where you say: "sticking and poor repeatability". I've seen this all too many times when sticking my nose where it doesn't belong (I do custom meter faces). IF the spring has only planar irregularities and the turns do not hit anything else (including adjacent turns) I see no reason why it should "stick". Look V E R Y carefully. The magnets are very strong and Murphy was wise. Look where the winding bobin is when the "stick" occurs. There are a lot of places where some foreign matter can cause this. Bobbins typically have four sides as well as an "inside" and "outside" surface to hit slivers and some of the clearance places are difficult to see into. Tip-toe lightly & gud luck. -- Steve N, K,9;d, c. i My email has no u's. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
WTD: Boonton 260A Q-Meter Meter Movement | Boatanchors | |||
Henry/ Phaestron meter needed | Boatanchors | |||
FA: TRIPLETT AC/DC Vintage Meter | Boatanchors | |||
FA: Vintage TRIPLETT AC Volt DC MA Meter | Equipment | |||
Ten-Tec 1209 2 to 6 meter transverter info needed | Equipment |