Ken Bessler wrote:

All these tests were done with a known good antenna
& new CQ-102 coax. Rig is a 1 year old Kenwood
TM-271A. All tests were done at an indicated 68 w
which is about normal for hi power from this rig.

I'll refrain from using the Pratt repeater until this is
fixed.

My question is this - have I done enough to assume
that the problem is not on my end? Sending in my
rig for service monitor testing would be difficult & a
genuine pain in the neck.

Ken KG0WX


The only way to determine your rigs frequency would be to put it on a
service monitor or at the least, a frequency counter.

I have 3 service monitors and would be glad to check your rig free of
charge if you pay postage both ways.

My test equipment is calibrated to an HP GPS frequency standard so I can
give you a pretty accurate measurement.

73
Andy
WD4KDN



--
"I didn't attend the funeral, but I sent a nice letter saying that I
approved of it."
�- Mark Twain