Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
I am working on a project for receiving a very narrow bandwidth signal
at 60 kHz. One of the design goals is to keep the power consumption to an absolute minimum. I'm trying to figure out how to run a pre-amplifier on less than 100 uW. So far I have found nothing. Any suggestions? -- Rick |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Preamp, RF amp and LNA. | Homebrew | |||
Preamp | Homebrew | |||
WANT D 104 UG8 PREAMP MIC | Swap | |||
Ant Preamp AW-203-1 ? | Antenna | |||
Ant Preamp AW-203-1 ? | Boatanchors |