| Home |
| Search |
| Today's Posts |
|
#1
November 9th 05, 01:27 PM
|
|||
|
|||
Yaesu FT-50RD Transmit Problem
Press the PTT button and it tries to transmit but immediately reverts back
to receive. Any programming ideas. I can't seem to find anything in the manuals. Jim, WB2HBZ |
|
#2
November 9th 05, 11:27 PM
|
|||
|
|||
|
Yaesu FT-50RD Transmit Problem
"Jim Dockery" wrote in message news:uWlcf.6309$41.1247@trndny04... Press the PTT button and it tries to transmit but immediately reverts back to receive. Any programming ideas. I can't seem to find anything in the manuals. Jim, WB2HBZ Have you checked the battery voltage? Could be low or going bad. Mine would give a beep and go blank, then come back to receive when the battery was low. Do you have a power supply to run it on as a test? Dan, W9FCC |
|
#3
November 10th 05, 04:02 AM
|
|||
|
|||
|
Yaesu FT-50RD Transmit Problem
Jim Dockery wrote:
Press the PTT button and it tries to transmit but immediately reverts back to receive. Any programming ideas. I can't seem to find anything in the manuals. Jim, WB2HBZ Hi, did you try a full CPU reset?? All memories will be gone afterwards so write them down!! Good luck!! 73 |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Yaesu FT-707 problem | Homebrew | |||
| yaesu ft 8100 problem | Equipment | |||
| FS: Yaesu and Icom Service Manuals ETC. | Swap | |||
| Yaesu FT-90R Current on Transmit | Equipment | |||
| Yaesu FT-90R Current on Transmit | Equipment | |||
Linear Mode
