Looking for an HP 8443A tracking generator interface cable that goes from
the tracking gen to the HP 141T mainframe spectrum analyzer. Cable is a D
sub type with 6 coaxial connections on each end. About a ft long or so.

Thanks, Colin VE7TNT

Colin Gunn wrote:
Looking for an HP 8443A tracking generator interface cable that goes
from the tracking gen to the HP 141T mainframe spectrum analyzer.
Cable is a D sub type with 6 coaxial connections on each end. About
a ft long or so.

http://www.glkinst.com/cables/hp_cables.htm

Hi
do like i did make one. This is low freq. I used a pice of RG-58 coax with a BNC Connector on one end (goes to the hp-8443a third low on the back of the hp-8443a unit) and the other end i solder a (female socket that fit the large AUX A connector the one with the three small connector in it. on the back of the hp-141t unit go to the top connector center pin and the braid goes to gnd). it works good.
Allan p
73
N8ZHC