| Home |
| Search |
| Today's Posts |
|
#3
February 10th 06, 10:01 PM
posted to rec.radio.amateur.equipment
|
|||
|
|||
Need help cloning or programming an Icom F3S handheld.
Hi Gary, yes I did build a level converter, found the schematic on the
net, it was a schematic directly from Icom for the programming cable. I did try holding all the buttons while powering up, didnt notice any difference in the display if it was in the cloning mode, I will try again. Its good to know that the radio's and programs are the same. Sounds like I just need to get the radio into cloning mode and then read its contents. Thanks for your reply and insights, it helped alot! 73s Tim N7XAU |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Useful Icom IC-R75 [R-75] Links for Facts and Information about the Icom IC-R75 [R-75] | Shortwave | |||
| Icom IC-R20 Programming Comments | Scanner | |||
| Last Day For Secret Icom Sale R-75 $425 | Shortwave | |||
| Last Day For Secret Icom Sale R-75 $425 | Swap | |||
| FS: ICOM IC-R10 HANDHELD RECEIVER | Swap | |||
Threaded Mode
