Jimmy,
just picked one up from SuperCheapAuto (or something like that) ... there is
one for AUD 10 and one for AUD 30.

Will put it in tomorrow and see how it goes

D.


"Jimmy" wrote in message ...

"D." wrote in message
om...
Hi,
I am beginner .. sorry if some of this seems like stupid question(s):

I have installed a ICom F2010(2020) into my Jeep.
The radio unit itself is installed in the back where the CD changer
was, the antenna cable is a bit too long, so it is stored in a loop.
Control unit is seperated with 8 meter cable from main unit and is
mounted underneath the ashtray (so basically it is sitting above the
gear box).

The antenna is mounted on the roof the car:
A GME 409L (ground independend), mounted on a spring S004

Frequencies used are in the 460Mhz-490Mhz range.

The problems I am experiencing now:
- Whenever the unit is Rx ... I can hear a whisling sound, which is
only audible if I accelerate (there seems to be a relationship to the
RPMs ?)
- If the car is stationary I can Rx ok, once the car is moving (maybe
50 kmh) the Rx is braking up

Is above normal, if not .. any ideas how to fix it ?

I am aware that I should shorten the antenna cable, rather than
looping it.
Could the transmition be causing the whisling noises ?
Is the antenna I am using a piece of s(*^&(^ and should I use a
different one ?
Thanks, D.

I had the same problem but with a PRM8010,
On Transmit you could hear an alternator noise, so all i need is a noise
filter?
Where abouts can i get one and how much??