julian814 wrote:
AndyS wrote:


Andy W4OAH in Eureka, Texas

Thanks, Andy. I think I've managed to find something a little better
than what I had in mind, anyway - Lindsay books sells a series of books
called the Impoverished Radio Experimenter. I've ordered two of them
that seem likely to have the information I need. My only concern now is
being able to run a tube receiver off of battery power, but I'm hoping
I can figure out something on my own.


Ralph Glatt

TUBES!! Tubes? Off of Battery, 6 Volt?, Vibrator? Inverter? 12 Volt B+
tubes ? Not since the 1950s ?
Am I reading too much between the lines ?

Yukio YANO, VE5YS

Except for the audio output stage, we can now run a radio on the power
used to to light the Dial on a Tubes Era Radio !

Yukio YANO wrote:
TUBES!! Tubes? Off of Battery, 6 Volt?, Vibrator? Inverter? 12 Volt B+
tubes ? Not since the 1950s ?
Am I reading too much between the lines ?

Yukio YANO, VE5YS

Except for the audio output stage, we can now run a radio on the power
used to to light the Dial on a Tubes Era Radio !

Andy writes:
Well, perhaps the OP is a "retro" hobbyist. I have met a few,
especially
youngsters who weren't born till after the ua709 was developed. Sort
of a
historical fascination.... Personally, I have had the hell shocked out
of me
enough to appreciate the privilege of using 14 volts or less (grin)...

Around here, you can usually pick up a transistorized car radio
for
about a dollar at garage sales and resale barns. I have yet to buy one

that didn't work. If you come to Eureka, Texas, I'll give you one for
free......

Andy W4OAH in Eureka, Texas


( If you've ever taken a beer to a job interview, you might live
in Eureka, Texas )

Yukio YANO wrote:
TUBES!! Tubes? Off of Battery, 6 Volt?, Vibrator? Inverter? 12 Volt B+
tubes ? Not since the 1950s ?
Am I reading too much between the lines ?

Yes, tubes. I have some that were pulled from circa 1960's television
sets, and I thought I'd use them, hoping that they'd be EMP resistant.
Been on kind of a survivalist kick, lately. Doesn't mean I'd be opposed
to using more modern equipment, though. One thing I saw that I liked in
one of the books I purchased was a loop antenna that uses transistors
to amplify the signal. Thought it might be easier than stringing up a
lot of wire. ;-)


Ralph Glatt

On 12 Dec 2006 09:54:50 -0800, julian814 wrote in . com:

Yukio YANO wrote:
TUBES!! Tubes? Off of Battery, 6 Volt?, Vibrator? Inverter? 12 Volt B+
tubes ? Not since the 1950s ?
Am I reading too much between the lines ?

Yes, tubes. I have some that were pulled from circa 1960's television
sets, and I thought I'd use them, hoping that they'd be EMP resistant.
Been on kind of a survivalist kick, lately. Doesn't mean I'd be opposed
to using more modern equipment, though. One thing I saw that I liked in
one of the books I purchased was a loop antenna that uses transistors
to amplify the signal. Thought it might be easier than stringing up a
lot of wire. ;-)

But the transistors almost certainly will be fried by EMP. If that's
not a concern, then by all means try it -- and share the design and
results with us, please!

--
Mike Andrews, W5EGO

Tired old sysadmin

julian814 wrote:
Yes, tubes. I have some that were pulled from circa 1960's television
sets, and I thought I'd use them, hoping that they'd be EMP resistant.
Been on kind of a survivalist kick, lately. Doesn't mean I'd be opposed
to using more modern equipment, though. One thing I saw that I liked in
one of the books I purchased was a loop antenna that uses transistors
to amplify the signal. Thought it might be easier than stringing up a
lot of wire. ;-)


Ralph Glatt

Andy writes:

If we have an EMP attack, who will you use the radio to listen to
???


Andy W4OAH

julian814 wrote:
Yukio YANO wrote:
TUBES!! Tubes? Off of Battery, 6 Volt?, Vibrator? Inverter? 12 Volt B+
tubes ? Not since the 1950s ?
Am I reading too much between the lines ?

Yes, tubes. I have some that were pulled from circa 1960's television
sets, and I thought I'd use them, hoping that they'd be EMP resistant.
Been on kind of a survivalist kick, lately. Doesn't mean I'd be opposed
to using more modern equipment, though. One thing I saw that I liked in
one of the books I purchased was a loop antenna that uses transistors
to amplify the signal. Thought it might be easier than stringing up a
lot of wire. ;-)


Ralph Glatt

Tubes can be fun. Just be careful not to get zapped by the high voltage
power supplies..that isn't fun.

EMP? If your radio is subjected to one of those you won't be needing a
radio.

Have fun with the tubes and 73,

Bill KU8H