ken scharf wrote:


Now to solder those chip caps and resistors! (They should be easier,
the AD9851 was the worst part to place with the tight spacing, all the
other parts have lead spacing at least twice as wide).

It's MUCH easier to begin with the easy parts! Start with the largest
chip caps and resistors, continue with the rest of the simple passives,
and then the largest ICs (largest pin spacing).

Finally, when you've honed your SMD skills, solder the large ICs with
the small pin spacings.

And give up the industrial-strength coffee for the duration :-)


--
73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.co.uk/g3sek