Home |
Search |
Today's Posts |
#8
![]() |
|||
|
|||
![]()
On Sep 1, 6:30*pm, confused wrote:
Highland Ham;644645 Wrote: Joe LeKostaj wrote:- In article , confused wrote:- hi joe thanks for your response.it has 3 pins on one side and on thicker pin like a small heatsink looks like this http://tinyurl.com/5ltz2j i'd appreciate any help on where to get another or an equivalant.i've looked through shed loads of smt code books online cant find same code.i've tried contacting kenwood???? thankyou- It could be a transistor as the other poster mentioned, but it could also be a voltage regulator IC. Your best bet would be to obtain a schematic and/or parts location diagram for your radio to help ID the component. Then your next stop would be Digi-Key or Mouser to look for a replacement. Also, try to determine what caused the part to fail before installing the new one so it doesn't meet the same fate. -Joe- ======================================== The OP did not mention the handheld radio model ,other than it is from Kenwood. *An instruction manual with circuit diagramme(s) of the relevant radio can highly likely be found at : *www.mods.dk Frank * GM0CSZ / KN6WH hi, thanks to all responders .there are three on the same board.the model is a th-26 handheld 2m.i've checked all the surrounding resistors and nearby passives .i think its a power supply problem.i dont want to power it up yet until i find out what this part doesi dont want to take another one of these ants lol out and check it out of circuit.smt is not my thing.i've searched for a free schematic so if anyone out there's got the schematic that'll be great .i'll take on board what you guys have said many thanks for taking the time. -- confused- Hide quoted text - - Show quoted text - More than likely your talking about a transistor maybe a mosfet The center lead is the collector or drain. Look for the same numbers on other parts and measure the forward to back ratio. To determine the kind of semi it is. should be quite ez. Mostly they using transistors like this for switching or buffers so I don't think it could be a darlington. It's either a npn or pnp. less likely a FET n channel or p channel It could still be a zener or a dual diode Zeners they connect the 2 leads together And a dual diode will have the same reading on each junction. 73 n8zu |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Wanted: Info: AEA SWR-121 | Swap | |||
Info wanted | Swap | |||
Wanted:SS-3 INFO | Boatanchors | |||
RFT EKD-300 info wanted | Equipment | |||
RFT EKD-300 info wanted | Equipment |