About Us

John Davis[_3_] · November 12th 14, 12:09 AM posted to rec.radio.amateur.homebrew

On 10/29/2014 1:21 PM, wrote:
gareth wrote:

Other than for interconnects, how often are flexible circuit boards
needed?

Well, one advantage of a flexible board design, I suspect, is impact
resistance, with just a bit of padding inside the case you could make a
radio you could play baseball (it would be the ball) and expect it to
survive... Hard PC boards can get cracked and broken by that kind of
impact.

Short alleged true story is a police officer chasing a suspect, Drew his
Motorola hand held and threw it striking suspect in the back of the head
and knocking him down,, Officer then went up, applied a matched pair of
nice shiny steel bracelets, Picked up the radio and radioed for a
transport car.

Not the most impressive story about those HT's I have, but a good one
for this post.
--
Home, is where I park it.

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com

rickman · November 12th 14, 01:50 AM posted to rec.radio.amateur.homebrew

On 11/11/2014 7:09 PM, John Davis wrote:
On 10/29/2014 1:21 PM, wrote:
gareth wrote:

Other than for interconnects, how often are flexible circuit boards
needed?

Well, one advantage of a flexible board design, I suspect, is impact
resistance, with just a bit of padding inside the case you could make a
radio you could play baseball (it would be the ball) and expect it to
survive... Hard PC boards can get cracked and broken by that kind of
impact.

Short alleged true story is a police officer chasing a suspect, Drew his
Motorola hand held and threw it striking suspect in the back of the head
and knocking him down,, Officer then went up, applied a matched pair of
nice shiny steel bracelets, Picked up the radio and radioed for a
transport car.

Not the most impressive story about those HT's I have, but a good one
for this post.

Lol. I used to work for a company that made military radios. They took
a heck of a beating... in the factory! Then the soldiers weren't so
gentle with them either. Every one had FR4 PCBs in them. Once a radio
saved a soldier's life by stopping a bullet... but the radio didn't
survive.

The problem with any PCB is not the FR4 material when it comes to shock.
It is the solder joints. Bang a surface mount chip enough and the
solder lets loose. That's why mil spec gear is exempt from the RoHS
restrictions. The lead in the solder makes is more flexible and more
tolerant of shock. But it will still let go before the PCB breaks if it
is shocked enough times.

--

Rick

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The way forward?	Wymsey[_2_]	Homebrew	10	November 1st 14 09:21 AM
PLEASE FORWARD TO DOUG	Douglas W Adair	Antenna	1	November 30th 08 05:12 PM
a forward on ars in the sechuan earthquake	an old freind	Moderated	0	May 14th 08 05:56 PM
Looking forward to my RF-2200	Count Floyd	Shortwave	1	November 8th 04 06:11 AM
Dead-key vs Forward swing	Jerry Oxendine	CB	5	July 8th 03 09:48 PM

Menu

About Us