About Us

January 14th 04, 12:07 AM

(Randy Chavis) wrote in message ...

Anybody have any ideas to lower noise in my FT-857 mounted in my F-150
pickup? S7-S9 noise (engine running, with NB ON) on 17M (Only band I've
tried on HF yet). Antenna is an Outbacker mounted on a mount I welded up
for my receiver hitch and puts the base of the antenna at about roof level.
Quiet as a mouse when truck is shut off. Go figure...hard to be "mobile"
with the engine off

--
Scott N0EDV
Gotta Fly or Gonna Die
http://corbenflyer.tripod.com
Building RV-4

you will find the problem in the fuel pump..Ford had a big porblem with it not
being grounded.They have a fix for it but you will have to talk to a Ford tech
to find it and buy it from them....

Randy

ARS: WB4UNA
Randy Chavis
247 Goff Court
West Columbia
S.C. 29172 Get ready to remove the tank,pump is inside..run the pump power through a pair of coax caps (about .1 to .25 OK ) mount them directly at the pump terminals on the tank..that will get about 90% of the noise..ground the tail pipe at the back bumper ,good braid ground. None of the Ford dealers that I contacted wanted to talk about the problem,never heard of it .. Good luck W4PQW

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ford unfriendly to Hams - help / advice needed.	Evan Platt	Equipment	51	October 19th 04 05:30 PM
Ford unfriendly to Hams - help / advice needed.	Evan Platt	Equipment	0	October 17th 04 08:09 PM
signal to noise ratio drops on connecting the antenna	Ashhar Farhan	Homebrew	6	September 22nd 03 10:54 PM
signal to noise ratio drops on connecting the antenna	Ashhar Farhan	Homebrew	0	September 18th 03 04:51 PM
Automatic RF noise cancellation and audio noise measurement	Dave Shrader	Homebrew	35	August 11th 03 01:07 AM