what is your top frequency you wish to use and what power levels??

you can make an swr meter good for 200w or so up to 70cms using pcb and a
very simple detector crt..
SM0VPO homepage has details..or look in rsgb vhf/uhf dx handbook..that has
microstrip (pcb) and torroid ring style bridges..they both work as i have
made many now...

g0zen
"Tom Bruhns" wrote in message
m...
This has been a hot topic recently! I just scanned an ARRL article
and a section of the test equipment chapter of the RSGB VHF/UHF
Handbook to send to someone else who is interested in making a
146/440MHz SWR monitor, and I just made a couple 100MHz-6GHz detectors
for someone else who is looking at monitoring SWR at 2.5GHz.

Seems to me the simple way for most folk to do it is to make a
microstrip coupler. You can use surface-mount components for the load
and detector and RF decoupling, and they'll work quite well up into
the GHz region, from my experience. As far as RF decoupling goes, you
should be able to do an adequate job on a circuit board...once the
detector turns the RF to DC, just put shunt capacitance to ground and
series inductance in the line. Pick the inductance as you would for
other VHF work: avoid inductors with self-resonances below the freq
of interest.

You probably have already seen the ARRL article I scanned, but if
you'd like the RSGB one, I could send it. But it's almost 4 megabytes
and may take you a while to download if you have a slow connection.

Cheers,
Tom


Uwe Langmesser wrote in message
...
I have been looking at various designs of VHF SWR bridges, mainly from
ARRL
sources like old QSTs and such, and I wonder if anybody here has built a
device like that.
For my experience level some of the old descriptions are just a touch to
cryptic or the design calls for parts which I can't locate (small feed
thru
caps are one of those items).
I would love to discuss this with a knowledgable builder.

73 Uwe