Hi,

I bought a big bag of surplus assorted trimmer pots at a radio rally 2
years ago. They're all unused, which I assumed meant they'd be
trouble-free. However, many of them seem to have gone very 'noisy' and
if one tries to wind them from one end to the other, the resulting
voltage readings jump around a lot and often have 'blank' areas for
part of an arc where no contact seems to be being made between wiper
and track. I immediately suspected that they'd probably require a good
dousing with switch-lubricant, but I'm not sure if that's the best
remedy and even if it is, there doesn't seem to be any serviceable
access into them through which one might be able to spray some lube.
The ones I have are between a quarter and one-half inch in diameter
approx and have a protective casing around them, unlike the good old
skeleton presets one could get at easily. Anyone care to give me any
tips on the best way to revitalise these old pots?

Thanks.
--

"What is now proved was once only imagin'd." - William Blake, 1793.