"andreas magun" wrote in message
...
Hi,

I have assembled a T2 phasing exciter (KK7B) and looked
at its output spectrum with a spectrum analyzer.

When pumping the exciter with quadrature sine wave signals it
works as expected (output power roughly 3 mW, sideband supression
better than 40 db).

However, when pumping with quadrature squarewave
signals of approximately the same power, the output power
drops by a factor of at least 20 db! I would have expected
much more power, similar to that obtained with sine wave pumping.

The quadrature phase signal was generated with a 74F74, the
quadrature signals being attenuated to give a power of approx. 10 dbm and
output impedances of approx. 50 Ohms.

Have you checked the RF power from your quadrature driver with resistive
loads? It can be very misleading if you measure it whilst connected to the
mixers.

Leon