Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
NEW PROGRAM
Program VERTUNE.exe analyses performance of half-wave, end-fed, vertical and similar antennas. See how power losses are distributed. A parallel L and C tuned circuit Z-matches the high impedance feedpoint to a coaxial line. Coil design, (dimensions, wire gauge, turns) is included. High radiating efficiency can be acheived with a poor ground electrode system. Download VERTUNE (41 kilobytes) in a few seconds, no un-zipping inconvenience, and run immediately. ---- .................................................. .......... Regards from Reg, G4FGQ For Free Radio Design Software go to http://www.btinternet.com/~g4fgq.regp .................................................. .......... |
#2
![]() |
|||
|
|||
![]()
Reg Edwards wrote:
Reg, Program VERTUNE.exe analyses performance of half-wave, end-fed, vertical and similar antennas. See how power losses are distributed. once again thanks for these GREAT antenna design aids! FYI, they do work in a "dosemu" environment under Linux (tried on dosemu 1.2.2.0). 73, Paolo IK1ZYW |
#3
![]() |
|||
|
|||
![]() "PaoloC" wrote in message ... Reg Edwards wrote: Reg, Program VERTUNE.exe analyses performance of half-wave, end-fed, vertical and similar antennas. See how power losses are distributed. once again thanks for these GREAT antenna design aids! FYI, they do work in a "dosemu" environment under Linux (tried on dosemu 1.2.2.0). 73, Paolo IK1ZYW ===================================== Dear Paola, Thanks very much for the information. I was not aware of it. I must take steps to publicise it. ---- Reg, G4FGQ |
#4
![]() |
|||
|
|||
![]()
Thanks for the VerTune program. I almost bought an auto-tuner to match a 10
meter high vertical until I saw that the calculated impedance was beyond the capabilities of the tuner. Saved money! Dick N3HKN "Reg Edwards" wrote in message ... NEW PROGRAM Program VERTUNE.exe analyses performance of half-wave, end-fed, vertical and similar antennas. See how power losses are distributed. A parallel L and C tuned circuit Z-matches the high impedance feedpoint to a coaxial line. Coil design, (dimensions, wire gauge, turns) is included. High radiating efficiency can be acheived with a poor ground electrode system. Download VERTUNE (41 kilobytes) in a few seconds, no un-zipping inconvenience, and run immediately. ---- .................................................. ......... Regards from Reg, G4FGQ For Free Radio Design Software go to http://www.btinternet.com/~g4fgq.regp .................................................. ......... |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Questions -?- Considering a 'small' Shortwave Listener's (SWLs) Antenna | Shortwave | |||
The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Antenna | |||
Question on antenna symantics | Antenna | |||
Poor quality low + High TV channels? How much dB in Preamp? | Antenna | |||
Communication During Blackout | Scanner |