Nuts for a project 1/4-32 = 6-2 but 1/4 inch across flats Where?

May 24th 05, 01:12 AM

Bill

Posts: n/a

Kaz wrote:

I need a source for "reduced standard" nuts.
These are 6-32 thread, but 1/4 across the flats instead of 5/16 inch.
Prefer brass, but steel will work.
Only need about 50 so distributors with minimum orders are out.
Mouser is close, but no go.

Thanks for any suggestions,
Kaz

Try http://www.mcmaster.com

-Bill

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AMATEUR RADIO NEWSLINEâ„¢ ANNOUNCES CREATION OF THE ROY NEAL, K6DUE, AMATEUR RADIO MENTORING PROJECT	Radionews	Shortwave	0	January 30th 04 10:02 AM
AMATEUR RADIO NEWSLINEâ„¢ ANNOUNCES CREATION OF THE ROY NEAL, K6DUE, AMATEUR RADIO MENTORING PROJECT	Radionews	CB	0	January 30th 04 10:01 AM
AMATEUR RADIO NEWSLINEâ„¢ ANNOUNCES CREATION OF THE ROY NEAL, K6DUE, AMATEUR RADIO MENTORING PROJECT	Radionews	Policy	0	January 30th 04 10:00 AM
AMATEUR RADIO NEWSLINEâ„¢ ANNOUNCES CREATION OF THE ROY NEAL, K6DUE, AMATEUR RADIO MENTORING PROJECT	Radionews	General	0	January 30th 04 10:00 AM
AMATEUR RADIO NEWSLINEÃ¢â€žÂ¢ ANNOUNCES CREATION OF THE ROY NEAL, K6DUE, AMATEUR RADIO MENTORING PROJECT	Radionews	Dx	0	January 30th 04 10:00 AM

All times are GMT +1. The time now is 07:39 PM.

Menu

About Us