Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
There are a couple of smoked resistors on the regulator board. I can not
trust the ohm meter reading so I wanted to verify its value. I am trying to avoid De-engineering the board. Now once the resistors are replace there may be something else that smoked the resistors too. Paul. "PS_DUDE" wrote in message ... hi paul, Tripp lite makes good supplies but lacks in the support side ! Good thing is the supplies use off the shelf parts or easy substituted parts from anywhre, http://www.mouser.com etc. What problem(s) are you having ? 73 ps dude |
#2
![]() |
|||
|
|||
![]()
"Paul P" wrote in
message ... There are a couple of smoked resistors on the regulator board. I can not trust the ohm meter reading so I wanted to verify its value. I am trying to avoid De-engineering the board. Now once the resistors are replace there may be something else that smoked the resistors too. Paul. Paul - Where are these resistors .. the typical linear supply has low ohm equalizing resistors across the NPN pass transistors .. and only a few in the regulation circuit off the LM723 pins .. for example a 1 K is usually used from pin 4 to the voltage adjustment potentiometer. gb |
#3
![]() |
|||
|
|||
![]()
Paul P wrote:
There are a couple of smoked resistors on the regulator board. I can not trust the ohm meter reading so I wanted to verify its value. I am trying to avoid De-engineering the board. Now once the resistors are replace there may be something else that smoked the resistors too. Paul. Here's a link to an Astron supply: http://www.seits.org/features/pwrsup.htm Assuming a typical 723 == pass transistors linear supply, it shouldn't be hard to figure out the values of the cooked resistors. The schematic at the link above serves well as a model for many (most?) of that type of supply. Combined with the LM723 datasheet, you can fix it. Ed "PS_DUDE" wrote in message ... hi paul, Tripp lite makes good supplies but lacks in the support side ! Good thing is the supplies use off the shelf parts or easy substituted parts from anywhre, http://www.mouser.com etc. What problem(s) are you having ? 73 ps dude |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Schematic for Heathkit PS-3 power supply | Boatanchors | |||
Astron RS-35M Power Supply Schematic | Policy | |||
SEC 20 Power Supply Schematic | Equipment | |||
FA: AMECO PS-1 Power Supply - 125v DC / 6.3v DC | Swap | |||
Derivation of the Reflection Coefficient? | Antenna |