LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6   Report Post  
Old May 3rd 06, 03:23 AM posted to rec.radio.amateur.homebrew,sci.electronics.design
Wes Stewart
 
Posts: n/a
Default Need further info on network analysis terms...

On 2 May 2006 15:14:29 -0700,
wrote:

Hi gang,

Reading through the instructions for this VNA it mentions some
important accessories; power spitters, 6db attenuators, 50 ohm
terminations, opens, shorts and throughs. What exactly is a "through"?


A through is a direct connection of the two test ports (cables). If
all devices under test (DUTs) were "insertable", i.e. had one male and
one female connector (or GR or 7mm sexless connectors) then the test
port cables could be joined directly, thus forming a through ("thru")

Unfortunately, a lot of DUTs have the same sex connector on both
sides, thus a calibration thru must be a double, same sex adapter
(barrel). Using such an adapter during calibration adds some
unavoidable length (and loss and mismatch) to the test path length.
One method of removing (some of) the effects of the barrel is to
replace it after calibration with a matched length male-female adapter
that remains in the test path.

And is it possible to make up accurate opens and shorts oneself that
are good enough for calibration purposes up to 1.3Ghz? Not talking
about any absolute standard here, like you'd get from HP themselves;
but just mid-tolerance stuff that'd be sufficient for reasonably
accurate amateur experiments?


Depends. For SMA stuff, an open and shorted connector wouldn't be too
bad. Type N is a little more problematic but probably doable for
moderately accurate measurements.

BTW, even HP (Agilent) doesn't offer "absolute" standards. :-;

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Utillity freq List; NORMAN TRIANTAFILOS Shortwave 3 May 14th 05 03:31 AM
Here's Your Answer, Todd.... K4YZ Policy 104 May 9th 05 09:43 AM
OLD motorola trunking information jack smith Scanner 1 December 12th 03 09:48 AM
Derivation of the Reflection Coefficient? Dr. Slick Antenna 104 September 6th 03 02:27 AM


All times are GMT +1. The time now is 09:36 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017