Hi,

Was wondering if there is any practical way to hear USB broadcasts on a
scanner ?

e.g., using AM, of course, but perhaps setting in some offset, or... ?

Thanks,
B.

"Robert11" wrote in message
...
Hi,

Was wondering if there is any practical way to hear USB broadcasts on a
scanner ?

e.g., using AM, of course, but perhaps setting in some offset, or... ?

Thanks,
B.

No simple and easy way just by setting the controls of the scanner.

It can be done if the scanner can be set to the AM mode and a signal from
a seperate source is used. That is you can use a signal generator that is
very stable and tune it to the frequency of the incomming signal . The
signal can also be injected at the IF frequency of the scanner.