Home |
Search |
Today's Posts |
#9
![]() |
|||
|
|||
![]() "Radiosrfun" wrote in message ... Anyone here with "in-depth" knowledge of the Bearcat 250 Scanner and repairs? The service manual you have is the only one I know of. Scanner manufacturers never update the manuals until there is a catalog number or model number change. During the life of a product there are changes made in production. I have an Electra schematic (engineering drawing) for the BC300 and it went through a dozen changes at the time the drawing was made. Finding a drawing like this for the 250 would be nearly impossible now. Electra often tack-soldered parts to the back of the boards. Maybe Q206 is on the back in your 250. Q206 serves as an amplifier to reduce the current in the Zener and improve regulation. If the voltage at the emitter of Q204 is much less than 8.4 volts, a good portion of the circuitry in the radio will not operate. You can try replacing the Q204 regulator with a 9 volt three terminal regulator feeding into a 1 amp diode. That should give you about 8.4 volts and has the bonus of overcurrent and thermal protection. The original design ran Q204 way too hot and it is a common failure point. Adding a heatsink and drilling a few vent holes helps. Many of the IC's in the radio are custom and very hard to find if one needs to be replaced. When I had a 250, I recall it being very sensitive to disturbances on the AC line, often hanging the scan cycle or corrupting the programming. With all the negatives about the 250, I'd look for a more recent model on Ebay to replace it. Something simple with 50 or 100 channels should be available cheap and it will perform better than the 250 ever did. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
SBE-33 Repairs - | Boatanchors | |||
SBE repairs | CB | |||
who repairs Alinco HF? | Swap | |||
Help with repairs Pro-92 | Scanner | |||
Grundig Repairs | Shortwave |