My Pro-2026 won't remember channels anymore.

I pulled it apart, and on the bottom side of the breadboard that houses the
main CPU, there is a horseshoe looking component that has seperated right
down the middle.

Any idea if this is the culprit? Did some other component used to live in
that spot, or can I simply solder the two halves of the horseshoe together
and get it to remember channels again?

Thanks.

Well, I just learned that that is jumper L201.

I just tried to save some freqs and it worked.

Still a mystery... Somehow the entire memory was clearned while I was parked
at my office.

If you have one of the 1st units with the three wire hookup,try this:

To alleviate the problem with loss of memory if the radio loses
complete power for any reason, I connected a battery pack to the
orange wire from the radio and I do not connect the orange wire to 12v
power source, Its set up the same as the BC-760xlt.

They had a "mem" loss problem on the 1st ones.

On Wed, 26 May 2004 20:11:10 -0700, "User" wrote:

Well, I just learned that that is jumper L201.

I just tried to save some freqs and it worked.

Still a mystery... Somehow the entire memory was clearned while I was parked
at my office.






remove SPAMSUCKS to reply