"dxAce" wrote in message
...


bobdabilda wrote:

Is it possible to connect two scanners to a single discone antenna and
have
them running together with satisfactory reception? What would I need to
do
this? Would I need some kind of vhf/uhf antenna splitter?
Thanks in advance guys.

This fellow makes some good ones.

http://www.stridsberg.com/

The stridsbergs are the way to go. I'm running a RS pro-2050 and pro-2030 at
the same time using a regular ol coax splitter. Seems to work fine for me,
though Im sure there is some signal loss. I'm using the cheapo RS scanner
antenna in the attic.

I have two scanners on a discone, and I get a noise on the other scanner
when one changes bands (they both do it to each other). A friend recommended
using 75 ohm coax and a tv splitter/amplifier. Amplified ones will isolate
the outputs to alleviate that problem.
Now a couple of points. Using 75 ohm coax rather than 50 ohm that the
scanner is looking for is ok, and will not hinder performance in any
measureable amount. The other is if you have a strong FM station near you,
it may cause overloading with the amplifier. Redice the gain if it is
adjustable.

WC

"MnMikew" wrote in message
...

"dxAce" wrote in message
...


bobdabilda wrote:

Is it possible to connect two scanners to a single discone antenna and
have
them running together with satisfactory reception? What would I need
to
do
this? Would I need some kind of vhf/uhf antenna splitter?
Thanks in advance guys.

This fellow makes some good ones.

http://www.stridsberg.com/

The stridsbergs are the way to go. I'm running a RS pro-2050 and pro-2030
at
the same time using a regular ol coax splitter. Seems to work fine for me,
though Im sure there is some signal loss. I'm using the cheapo RS scanner
antenna in the attic.