Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
I am looking for a small travel wall wart (power supply) that converts
120VAC to 12VDC. My Rat Shack supplies are very "noisy" when used with my R10 -- lotsa 60 cycle interference. My big shack supplies (Astron) are quiet but too big. This one looks pretty good: http://www.allelectronics.com/cgi-bi...250&type=store It would be nice if the prongs folded down, though. Any recommendations? Ken (to reply via email remove "zz" from address) |
#2
![]() |
|||
|
|||
![]() "Ken" wrote in message news ![]() I am looking for a small travel wall wart (power supply) that converts 120VAC to 12VDC. My Rat Shack supplies are very "noisy" when used with my R10 -- lotsa 60 cycle interference. My big shack supplies (Astron) are quiet but too big. This one looks pretty good: http://www.allelectronics.com/cgi-bi...250&type=store It would be nice if the prongs folded down, though. Any recommendations? Ken (to reply via email remove "zz" from address) I doubt the supply itself is the source of noise- it i simply conducting noise from the AC mains to your receiver. Try winding the DC leg on #43 toroids to choke off any RF along the line. Dale W4OP |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Need quiet 6V wall wart for Icom R10 receiver/scanner | Equipment | |||
Need quiet 6V wall wart for Icom R10 receiver/scanner | CB | |||
Need quiet 6V wall wart for Icom R10 receiver/scanner | Equipment | |||
Need quiet 6V wall wart for Icom R10 receiver/scanner | Equipment | |||
Wall map | Dx |