| Home |
| Search |
| Today's Posts |
|
|
|
#1
April 30th 05, 01:45 AM
|
|||
|
|||
This is the file i am using:
http://spectrum.ic.gc.ca/pub/tafl/do63.zip I got it from this site: http://spectrum.ic.gc.ca/tafl/tafindxe.html and used the converter on the bottom of the page to make it an excel file. Steve |
|
#2
April 30th 05, 01:59 AM
|
|||
|
|||
|
They certainly aren't specific are they?
However, it looks as though they're talking about frequencies from the repeater point of view. So start with the tx frequency. If you hear both sides of the conversation OK then you've got it right. -- Dave S "BIGSteve" wrote in message oups.com... This is the file i am using: http://spectrum.ic.gc.ca/pub/tafl/do63.zip I got it from this site: http://spectrum.ic.gc.ca/tafl/tafindxe.html and used the converter on the bottom of the page to make it an excel file. Steve |
|
#3
April 30th 05, 03:56 AM
|
|||
|
|||
|
From what I could make out, it looks like 400 mhz frequencies with a 5 meg
split. The repeaters will normally be on the lower of the 2 freqs so the 413to 14 mhz range is what you want to program in. "BIGSteve" wrote in message oups.com... This is the file i am using: http://spectrum.ic.gc.ca/pub/tafl/do63.zip I got it from this site: http://spectrum.ic.gc.ca/tafl/tafindxe.html and used the converter on the bottom of the page to make it an excel file. Steve |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Advice on buying a scanner | Scanner | |||
| Choke Baluns again. New program | Antenna | |||
| Coax signal deteriotion to Scanner | Scanner | |||
| FS: scanner stuff | Scanner | |||
Hybrid Mode
